Scope Of Delivery; Type Key - Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung

2
1
Fig. 2: Rating plates
Fig. 3: Functional assemblies
Fig. 4: Motor impeller unit
4.1

Scope of delivery

4.2

Type key

Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
Rating plates (Fig. 2)
1 Pump rating plate
• There is a serial number on the pump rating plate. It must be specified e.g. for ordering
spare parts.
• The drive rating plate is located on the side of the electronic module. The electrical con-
nection must be designed according to the specifications on the drive rating plate.
Functional modules (Fig. 3)
Item Name
1 Hydraulic unit
2 Differential pressure
sensor (optional)
3 Drive
4 Motor
5 Electronic module
6 Impeller
7 Lantern
Table 3: Functional assemblies
The motor drives the hydraulic unit. The electronic module takes over the control of the mo-
tor.
The hydraulic unit is not a ready-to-install assembly due to the continuous motor shaft. It is
disassembled for most maintenance and repair work. For information on maintenance and
repair work, see "Maintenance" [} 224] section.
Motor impeller unit
The impeller and lantern together with the motor form the motor impeller unit (Fig. 4).
The motor impeller unit can be separated from the pump housing for the following purposes:
• The motor with the electronic module must be turned to a different relative position to
the pump housing.
• Access to the impeller and mechanical seal is required.
• The motor and hydraulic unit must be separated.
The pump housing can remain in the pipe.
Observe "Permitted installation positions and change of the arrangement of components be-
fore installation" [} 140] section and the "Maintenance" [} 224] section.
• Pump
• Installation and operating instructions and declaration of conformity
• Wilo-Smart Connect Module BT
• Threaded cable glands with sealing inserts
Example: Stratos GIGA2.0-I 65/1-37/4,0-xx
Stratos GIGA Pump designation
2.0 Second generation
2 Drive rating plate
Description
The hydraulic unit consists of pump housing, impeller and
lantern.
Differential pressure sensor with connection and fixation
elements
The drive consists of a motor and an electronic module.
Electronic unit
en
133