Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung Seite 132

en
Fig. 1: Pump overview
132
No. Component
20 Spacer on mechanical seal
21 Impeller
22 Impeller nut
23 Impeller nut washer
24 Pump housing
25 Rotating unit on mechanical seal
26 Stationary ring on mechanical seal
27 Protective plate
28 Air vent valve
29 Fastening screws from the motor impeller unit, 4x
30 Transport lug, 2x
31 O-ring for contacting
32 Twin-head pump flap
33 Shim of twin-head pump flap
34 Axle of twin-head pump flap
35 Axle bore screw plug, 2x
36 Drilled hole for installation bolts
37 Key
Table 1: Arrangement of the main components
Item Name
1 Transport lugs
2 Pump housing
3 Motor
4 Graphic display
5 Electronic module
6 Electrical fan
7 Protective plate in
front of lantern win-
dow
8 Slot for Wilo-Smart
Connect Module BT
9 Differential pressure
sensor
Table 2: Description of the pump
• Item 3: The motor with mounted electronic module can be rotated relative to the lantern.
Observe the instructions in the "Permitted installation positions and change of the ar-
rangement of components before installation" [} 140] section.
• Item 4: The display can be rotated in 90° steps as required. (see section "Electrical con-
nection" [} 150]).
• Item 6: An unobstructed and free air flow must be ensured around the electric fan. (see
"Installation" [} 138] section).
• Item 7: The protective plate must be dismantled for the leakage check. Observe the safety
instructions in "Commissioning" [} 162] section!
• Item 8: for installing the Wilo-Smart Connect Module BT, see "Installation Wilo-Smart
Connect module BT" [} 161] section.
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
Explanation
Used for transporting and lifting the components. See "In-
stallation" [} 138] section.
Install according to "Installation" section.
Drive unit. Forms the drive together with the electronic
module.
Provides information about settings and pump status.
Self-explanatory user interface for setting the pump.
Electronic unit with graphic display.
Cools down the electronic module.
Protects against rotating motor shaft.
Wilo Connectivity Interface as slot for the Bluetooth module
2 ... 10 V sensor with capillary tube connections on flanges
of suction and discharge side