PARTS NAME
Indoor unit
1 Room temperature sensor
1
1
1
1
2 Front panel
2
2
2
2
3
3
3 Air inlet grille
3
3
4 Air filter
4
4
4
4
5
5
5 Air outlet
5
5
6 Horizontal air flow flap
6
6
6
6
7 Vertical air flow flap
7
7
7
7
8 Display panel
8
8
8
8
9 Infrared signal receiver
9
9
9
9
!
!
! Remote controller (wireless)
!
!
"
"
" Remote controller (wired, sold separately)
"
"
NAMES AND FUNCTIONS OF INDICATORS AND CONTROLS
ON INDOOR UNIT
Display panel
The operating conditions are indicated below.
1.
(OPERATION) lamp (green)
This lamp goes on during operation.
2.
(TIMER) lamp (green)
This lamp goes on white the timer reserved.
NOTES
In case of timer setting by wired remote controller,
In case of twin and group combination,
3.
(STAND BY) lamp (orange)
This lamp lights up when the power is turned on or right after heating operation starts or during defrost operation
and thermo control.
CAUTION
When the power is turned on for the first time after installation,
setting of addresses of systems and units. When the power is turned on the next time,
approximately 1 minute.
While the above lamp is on, all the commands from the remote controller cannot be received. However, this is
not a malfunction or failure.
TEMPORARY button
If you misplace or lose the remote controller or its batteries are
exhausted, push the TEMPORARY button.
1. Open the air inlet grille to push the TEMPORARY button.
You can lift the grille up to an angle wherever it will remain fixed.
Do not lift the grille any further when it stops with a clicking sound.
2. Push the TEMPORARY button to start the air conditioner.
Push this button once again to stop it. (
EN
"
!
CODE No.
SET
DATA
SETTING
TEST
UNIT No.
R.C.
No.
H
TEMP.
ON / OFF
TIMER SET
FAN
MODE
TIME
SWING/FIX
VENT
FILTER
RESET TEST
SET CL
UNIT
lamp does not light.
lamp goes on main unit only. (
see page 23.)
3
2
4
6 5
8 9 7
1 2 3
see page 7.)
lamp lights up for approximately 5 minutes for
lamp lights up for
TEMPORARY button
3
1