Operation - Bartscher 1K2200 GL Original-Gebrauchsanleitung


Never place the device at the edge of a table to avoid tilting or falling.

Never put the device in a moist or wet area.

Do not place the device near open flame, electric heaters or other heat source.

Place the device so that the plug is easily accessible so as to quickly disconneet the
device if the need arises.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!
Connect the device only to properly installed single
socket with protective terminal.

The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.

5.2 Operation


Before you start using the appliance, clean it following the instructions in point 6
"Cleaning".

Plug the appliance into the single electric socket.

Turn the appliance on using the on/off switch. Initially the appliance starts in the stand-
by mode and you need to activate it by pressing and holding (for 2 sec.) the knob.

Set the desired temperature using the temperature control (level 1 to 9). The red
control light will appear that indicates the appliance is working.
- 25 -