Bosch GTM 12 Professional Originalbetriebsanleitung Seite 52

OBJ_BUCH-302-005.book Page 52 Tuesday, June 9, 2009 2:19 PM
52 | English
Never reach behind the saw blade in order
to hold the workpiece, remove saw
dust/wood chips or for any other reason.
The clearance of your hand to the rotating
saw blade is too small.
Guide the workpiece against the saw blade
only when the machine is switched on. Oth-
erwise there is damage of kickback, when
the saw blade becomes wedged in the work-
piece.
Only saw one workpiece at a time. Work-
pieces placed on top or aside of each other
can cause the saw blade to jam or the work-
pieces to move against each other while saw-
ing.
Always use the parallel guide or the angle
guide. This improves the cutting accuracy
and reduces the possibility of saw blade
binding.
1 609 929 U05 | (9.6.09)
If the saw blade should jam or when inter-
rupting work, switch the machine off, hold
the workpiece in place and wait until the
saw blade has come to a complete stop.
Never attempt to remove the workpiece as
long as the saw blade is running, otherwise
kickback can occur. Determine and correct
the cause for the jamming of the saw blade.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Bosch Power Tools