Operation - Cameo LUXIS FC Bedienungsanleitung

9 ROTARY-PUSH ENCODER
Four different spotlight modes are available as direct access for quick and easy adjustment of the
spotlight without an external controller. These can be selected in the Encoder Mode menu item
(Dimmer UC1, CCT, HSI, Direct LED).
If one of the DMX modes is activated and there is no DMX signal on the device, the default mode
can be used with the encoder. Rotate or press the encoder to activate the mode. Change a
numerical value (e.g. dimmer) by turning the encoder. If the preset mode has multiple channels,
press the encoder to go to the next channel, etc.
If "Disabled" is selected in the Encoder Mode menu item, none of the four spotlight modes are
available for direct access and the encoder is used to navigate in the menu.
10 SAFETY
Securing lug for attaching the spotlight.

OPERATION

PLEASE NOTE
As soon as the spotlight is correctly connected to the power supply, the following are displayed in
succession: "Update wait ..." (for service purposes only), "Welcome to Cameo", the model name
and the software version. After this process, the spotlight is ready for operation and the previously
activated operating mode is launched.
The main display is activated automatically if no input is made within approximately 30 seconds.
To navigate one level up in the submenus, briefly press MENU.
• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input or
the iDMX stick, the characters on the display begin to flash.
• Briefly pressing UP when in the main display rotates the display by 180°.
• To quickly change a value, such as the DMX start address, press and hold UP or DOWN.
13