Before Commissioning; Assembly; Commissioning - Scheppach 5903819901 Original Bedienungsanleitung

Vibration emissions value a
tions) and uncertainty K determined per EN 62841-2-3
& EN 62841-1:
Vibration emission value (3-axle)
Typical weighed vibration a
Uncertainty K
7.

Before commissioning

• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
m ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
• The brushing roller must be able to run freely.
• Before pressing the on/off switch, make sure that
the brushing roller is correctly fitted and that moving
parts run smoothly.
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
Connection to the mains
Check whether the network to which you connect the
machine is properly earthed according to the valid
standards and whether the outlet is in good condition.
26 | GB
(vector sum, three direc-
h
= 7,85 m/s²,
h
= 1.5 m/s²
www.scheppach.com

8. Assembly

m WARNING! Electric shock
Unplug the mains plug from the socket before carrying
out any work on the machine!
Installing the cover and front handle (Fig. C)
1. Align the holes in the cover (9) with the holes on
the device and bolt them together with the Phil-
lips-head screwdriver (14). Use the Allen key (13)
for this.
2. Connect the front handle (1) to the fixing point on
the device and secure it with the hexagon socket
screws (12). Use the Allen key (13) for this purpose.
Fitting/replacing the brushing roller (Fig. A + C)
1. Loosen the fixing screw (10) and fold the cover (A)
to the side.
2. Push the brushing roller (8) onto the motor shaft
(B). Depending on whether the brushing roller (8)
has feather key grooves, make sure that the feath-
er keys (15) are in the grooves of the motor shaft
(B) and the washer (16) is mounted.
3. Secure the brushing roller (8) by actuating the
shaft lock (11) and tightening the clamping screw
(18) with the washer (17).
4. Close the cover (A) and secure it with the fixing
screw (10).
5. Disassembly takes place in reverse order.
9.

Commissioning

Selection of the brushing roller
Depending on the application and the material to be
processed, different brushing rollers are available (not
necessarily included in the scope of delivery):
Cotton brush (Art. No. 7903800712)
Machining type: Polishing
Suitable for: Marble, lacquered and unlacquered met-
als
Synthetic fibre brush (Art. No. 7903800713)
Machining type: Preparing and polishing surfaces
Suitable for: Flat and level metal surfaces
Plastic fibre brush (Art. No. 7903800714)
Machining type: Clean
Suitable for: Flat and irregular wood, stone, metal sur-
faces, as well as tiles and joints