Dab+ Operation - LENCO CD-400GY Bedienungsanleitung

Volume Control
Press the VOLUME + / - button to change the volume. This CD player has a hearing protection and will limit the
volume and give you a warning when the volume becomes too high; you have to press the ENTER (12) button to
confirm that you want to increase the volume, then press the VOLUME + (3) button to increase the volume level.
Adjusting the DAB+ / FM Reception
The earphone wire serves as the antenna. Therefore fully extend the earphone wire and place the unit to a
location to ensure a good DAB+ / FM reception.

DAB+ OPERATION

The first time in the DAB+ mode, it will automatically scan for available DAB+ stations. Wait until the scanning has
finished. The display will show the scanning progress. After scanning it will tune to the first station.
Auto Scan
1. Turn on the unit in DAB+ mode.
2. Press and hold the SCAN button to start auto-scanning the available stations.
Manual Scan
By using the manual scan operation, it can help you to adjust the unit position or search station that is missed
while auto scanning.
1. Turn on the unit in DAB+ mode.
2. Press and hold the MENU button to access the menu control.
3. Press the or
4. Press the or
5. Press the ENTER button to confirm. Adjust the unit position for the best reception if necessary.
6. To select another channel (5A-13F), press the
confirm.
7. When the station is found, press the ENTER button to select.
8. To quit manual scan, press the MENU button repeatedly.
Tuning
After scanning all the available DAB stations, press the
list. Then press the ENTER button to tune to this station within a few seconds.
button until "Manual tunel" is displayed and then press the ENTER button.
button to select the desired channel (5A-13F).
or button and then press the ENTER button to
or button to display and navigate the station
13