Inhaltsverzeichnis
Werbung
CYLINDER AND PISTON
Piston ring
1. Measure:
Ring side clearance
G
Use a feeler gauge 1.
Out of specification → Replace the pis-
ton and rings as a set.
NOTE:
Clean carbon from the piston ring grooves and
rings before measuring the side clearance.
Top ring
(0.0012 ~ 0.0026 in)
2nd ring
(0.0008 ~ 0.0022 in)
2. Position:
Piston ring
G
(in cylinder)
NOTE:
Insert a ring into the cylinder and push it
approximately 10 mm (0.39 in) into the cylin-
der. Push the ring with the piston crown so that
the ring will be at a right angle to the cylinder
bore.
a 10 mm (0.39 in)
3. Measure:
Ring end gap
G
Out of specification → Replace.
NOTE:
You cannot measure the end gap on the
expander spacer of the oil control ring. If the oil
control ring rails show excessive gap, replace
all three rings.
Top ring
2nd ring
Oil ring
4 - 45
ENG
Side clearance:
Standard
0.030 ~ 0.065 mm
0.020 ~ 0.055 mm
End gap:
Standard
0.20 ~ 0.30 mm
(0.008 ~ 0.012 in)
0.35 ~ 0.50 mm
(0.014 ~ 0.020 in)
0.20 ~ 0.50 mm
(0.01 ~ 0.02 in)
<Limit>
0.12 mm
(0.005 in)
0.12 mm
(0.005 in)
<Limit>
0.55 mm
(0.022 in)
0.85 mm
(0.033 in)
—
Werbung
Inhaltsverzeichnis
