Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
34
Electrical connection
Connecting the device
1
Connect the device to a mains connection with protective earthing.
2
Only connect the device via a current limiting device of the building
installation with the possibility of voltage disconnection.
3
Switch off the mains voltage before removing the intermediate cover.
4
Use shielded cables for all low voltage connections.
5
Place the cable shields on one side of the central earth terminal
in the housing.
6
Only connect electric strikes that are designed for 12 V DC voltage, whose
current consumption does not exceed 250 mA and are equipped with
a recovery diode.
7
Connect the monitoring contact of the electric strike or another contact
connected to this input as a normally closed or normally open contact.
The input is edge controlled. The control system reacts to both
switching edges.
8
If consumers other than electric strikes are connected, provide suitable
interference protection measures (e.g. recovery diode for inductive
consumers).
9
Note also the freewheeling state output voltage, if applicable.
10 To insert the cable into the housing, cut the rubber grommets crosswise
and push the cable through bluntly.
Electrical connection
Werbung
Inhaltsverzeichnis
