Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MD 9260 Clamp Meter
Sicherheit
more and release to exit CREST-MAX capture mode. Auto-ranging and Auto-Power-Off are
disabled automatically in this mode.
Backlighted LCD display
Press the SELECT button for 1 second or more to toggle the LCD backlight. The backlight will
also be turned off automatically after 32 seconds to extend battery life.
Relative-Zero (
) mode
Relative-Zero allows the user to offset the meter consecutive measurements with the main
display displaying reading as the reference value. Press the REL button momentarily and
release to toggle Relative-Zero mode.
Manual or Auto-ranging
Press the RANGE button momentarily and release to select manual-ranging, and the meter
will remain in the range it was in, the LCD
turns off. Press the button again to step
through the ranges. Press and hold the button for 1 second or more and release to resume
auto-ranging.
Note: Manual-ranging feature is not available in Hz and
function ranges.
Set Beeper Off
Press the RANGE button while turning the meter on to temporarily disable the Beeper feature.
Turn the rotary switch OFF and then back on to resume.
Auto-Power-Off (APO)
The Auto-Power-Off (APO) mode turns the meter off automatically to extend battery life after
approximately 34 minutes of no rotary switch or push button operations. To wake up the
meter from APO, press the SELECT button momentarily and release or turn the rotary switch
OFF and then back on. Always turn the rotary switch to the OFF position when the meter is not
in use
Disabling Auto-Power-Off
Press and hold the SELECT button while turning the meter on to temporarily disable the Auto-
Power-Off (APO) feature. Turn the rotary switch OFF and then back on to resume.
12
Werbung
Inhaltsverzeichnis
