Recline Adjustment; Height Adjustment - Joie Signature i-Prodigi Bedienungsanleitung

Use Side Impact Protection
see images -
11 12
1. The enhanced child restraint is delivered with removable side
impact protection pod. This side impact protection pod MUST be
used on the door side of the vehicle. Installation shown in
2. Press the release button to remove side impact protection pod.

Height Adjustment

for Head Support and Shoulder Harnesses
see images -
13 14
1. Please adjust the head support and check if the shoulder harnesses
are at the correct height according to
!
The shoulder harness height must be even with or just below the top
of child's shoulders. 13
Lift up the head support adjustment lever, meanwhile pull up or down
the head support until it snaps into one of the 8 positions. The head
support positions are shown as
7
11
&
13 14
.
14

Recline Adjustment

see images
Squeeze the recline adjustment button to adjust the enhanced child
restraint to the proper position.
.
Adjust the seat recline to any of the 8 recline positions for optimal head
and neck support.
12
Rearward Facing Mode
(Child height 40cm-125cm/ Child weight
22.5kg)
see images
!
Please install the enhanced child restraint on the rear vehicle seat
and then put the child in the enhanced child restraint.
1. Press the harness adjustment button while pulling the shoulder
harnesses to the desired length (Pull from below the fixed shoulder
pads to lengthen).
2. Unlock the buckle of the harnesses by pressing the red button.
3. Fix the buckles on the both sides of seat to make placing the baby
more convenient.
4. Place the child into the enhanced child restraint and pass both arms
through the harnesses.
5. Engage the buckle. Please refer to
6. Pull down the adjustment webbing and adjust it to the proper length
to make sure your child is properly secured.
!
Always keep child secured in harness and properly tighten the
harness by removing any slack.
-
15 16
15
16
-
17 21
17
19
20
18
21
8