Introduction; Device Description, (Fig. 1-23) - Scheppach BASA3 Original Bedienungsanleitung

1.

Introduction

Manufacturer:
scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no lia-
bility for damage to the device or caused by the device
arising from:
• Improper handling
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed.
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
34 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description, (Fig. 1-23)

1. Adjusting knob for saw belt tension
2. Housing door
3. Door lock (top)
4. Saw band guard
5. Saw band guide
6. Parallel stop
7. Guide rail
8. Door lock (bottom)
9. Hand wheel for cutting speed
10. Transport handle
11. Travel fixture
12. Machine stand
13. Main frame
14. On/off switch
15. Quick-release lever, saw belt tension
16. Tailstock holder
17. Wing screw
18. Adjustment screw, angle adjustment
19. Electrical power connection
20. Engine
21. Suction port
22. Adjusting knob, angle setting, saw bench
23. Quick-release lever, angle adjustment
24. Saw table
25. Table inlay
26. Saw band
27. Adjustment handle for the saw band guard
28. Adjusting knob for top band wheel
29. Mounting plates for handle
30. Transverse cutting gauge
31. Thrust bearing mount
32. Top and bottom guide rollers
33. Parallel stop clamping lever
34. Door arrester
www.scheppach.com