Bartscher 900-Serie Bedienungsanleitung Seite 44

Substituting the By-Pass (figg.11, 13 – pag.5, 6)
To substitute the by-pass, firstly the knobs (1) must be removed and then the drip pan (2). When the
work area is clear, unscrew the by-pass (7) with a screwdriver and substitute it with the by-pass
suitable for the type of gas to be used, shown in tables 2, 3, 4, 5, 6. Reassemble the by-pass and
tighten it well.
Put back the control panel, the drip pan and the knobs.
Substituting the pilot burner nozzle (figg.11, 14 – pag.5, 6)
To substitute the nozzle of the pilot burner, first of all, the knobs (1) must be removed, the drip pan
(2) and the control panel (3), as in figure 14. Unscrew the fitting (8) which fixes the gas supply pipe
of the pilot (9) and remove the nozzle (10). Substitute it with the nozzle suitable for the type of gas
to be used, shown in tables 2, 3, 4, 5, 6. Then proceed to assemble the new nozzle, reposition the
pipe and tighten the fitting fully. When all this has been done, put back the parts removed
previously.
Gas fry-top (fig. 15 – pag.6)
To light the burner of the fry-top, proceed in the following way:
- turn the knob (1) from the off position
- press down to the bottom;
- push the button of the piezoelectric lighter (2)
- keep the knob pressed down until the thermocouple heats up, keeping the pilot lit; this can be
checked through the slit in the control panel;
- light the main burner, positioning the knob in one of the eight possible positions, choosing the
one most suited to the type of cooking desired, considering that they correspond indicatively to
the temperatures shown below:
Position [N°]
Temperature [°C]
To put out the main burner, it is necessary to turn the knob to the right into the on position
put out also the pilot, turn the knob again into the off position
Electric fry-top (fig. 16 – pag.6)
To light the fry-top, proceed in the following way:
- Turn the knob (1) of the thermostat into the position which corresponds to the cooking
temperature desired; the two lights come on, the green light stays on all the time to show that
there is tension, whilst the orange one goes off as soon as the hotplates reach the desired
temperature.
To turn off the hotplate turn the knob into the 0 position.
ATTENTION! Only use the appliance under surveillance. Never let the hotplates function
with nothing on them.
INSTRUCTIONS FOR USE
into the on position

1 2 3
150 175 200
Pag. 44/68
;
to light the pilot burner;
4 5 6
225 250 275
 .
7 8
300 325
, to