Closing The Door; Installation - AEG SKD71800S0 Benutzerinformation

50 www.aeg.com
Problem
The temperature in
the refrigerator is
too high.
Upper or lower
square is shown in
the temperature
Display.
dEMo appears on
the Display.
The buzzer sounds.
The Display is red.
6.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center.

6.2 Closing the door

1. Clean the door gaskets.

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
All manuals and user guides at all-guides.com
Possible cause
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
The door is not closed
correctly.
Solution
Make sure that there is
cold air circulation in the
appliance.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start works
regularly.
Refer to "Door open
alarm".
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli- Ambient temperature
mate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C