Panasonic EY7442 Bedienungsanleitung Seite 7

III. ASSEMBLY
Attaching or Removing Bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
This tool is equipped with a keyless
drill chuck.
1. Attachment
Insert the bit and turn the lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
2. Removal
Turn the lock collar counterclock-
wise (looking from the front), then
remove the bit.
NOTE:
If excessive play occurs in the chuck,
secure the drill in place and
open the chuck jaws by turning the
lock collar and
(left-handed screw) with a screw-
driver by turning it counterclockwise
(viewed from the front).
EY7442_7450_7950(EU).indb 7
Attaching or Removing Bat-
tery Pack
Alignment marks
Lock collar
Support handle
tighten the screw
-  -
1. To connect the battery pack:
Line up the alignment marks and at-
tach the battery pack.
• Slide the battery pack until it locks
into position.
2. To remove the battery pack:
Pull the button from the front to re-
lease the battery pack.
Button
Place the support handle at your fa-
vorite position and tighten the handle
securely.
Tighten
Loosen
Always use the support handle to
ensure operating safety.
2011-3-1 11:33:57