Chicco SYNTHESIS Gebrauchsanleitung Seite 34

HOW TO ADJUST THE HEIGHT OF
THE SAFETY HARNESS
1. Unfasten the safety harness, press-
ing the red button located on the
buckle (diag. 5).
2. Remove the two straps from the
belts and the two edges of the
safety belt as shown in fig. 6.
3. Remove the two parts of the safety
harness from the rear of the child
car seat, and insert them into the
hole which is most suitable to the
child's height (diag. 7).
4. Re-insert the shoulder straps, if pre-
sent.
HOW TO FIT THE CHILD CAR SEAT
INTO THE CAR
5. Position the handle of the child car
seat vertically, by pressing the two
lateral adjusting buttons (fig. 8) and
extract the stabilizer foot (9a).
6. Place the child car seat onto the car
seat where you wish to fit it (diag.
9b).
7. Pull the car safety belt and lock it
into the appropriate buckle, slid-
ing the lap belt into the two side
guides of the child car seat marked
with the blue arrows (diag. 10).
8. Hold the diagonal belt and pull it,
until the lap belt is tensioned cor-
rectly (diag. 11). At the end of these
operations, check that the lap belt
is still locked correctly into the ap-
propriate guides marked with the
blue arrows.
9. While keeping the diagonal belt
tensioned, slide it into the guide
marked with the blue arrow, lo-
cated on the rear of the backseat
(diag. 12). Tension the belt as much
as possible, checking that it is not
slack or twisted.
WARNING! After fitting the child car
seat, always check that car safety
belt is tensioned correctly, and that
it is safely locked into its buckle. Also
check that the buckle of the car safety
belt does not come into contact with
the points where the safety belt fas-
tens the child car seat: it could make
the child car seat unsafe in the event
of an accident.
CAUTION! For your child's safety: Do
not fasten the child car seat with
the car safety belt in any other ways
than as indicated in this instructions
booklet!
10. Turn the handle, as shown in diag. 13.
HOW TO PLACE THE CHILD INTO
THE CHILD CAR SEAT
11. Press the grey button located at
the front of the child car seat and,
while pressing the button, loosen
the two belts of the child car seat
(diag. 14).
12. Unfasten the buckle of the safety
belts pressing the red button
(diag. 15).
13. Place the child into the child car
seat and fasten the harness (diag.
16). The shape of the buckle
prongs does not allow you to in-
sert and lock a single harness strap
only.
14. Tension the safety harness, pulling
the appropriate adjustment belt
(diag. 17), and make sure that it fits
the child correctly.
HOW TO ADJUST THE HANDLE
The handle of the child car seat can
be adjusted to 4 positions (diag. 18):
A Position for car transportation
X Middle position: Never use this po-
sition
B Position for hand transportation
C Rocking and stroller position
D Baby chair position
34