Help In Case Of Malfunction; Storage; Storing The Electric Lawnmower - AL-KO 3.22 E easy Betriebsanleitung

Help in case of malfunction

9 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
Malfunction
Motor does not
start.
Motor loses power.
Motor stops during
mowing.
Grass catcher is not
filled sufficiently
Mains cable

10 STORAGE

Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.

10.1 Storing the electric lawnmower

1. Switch off the appliance: Remove the safety
key.
2. Set the cutting height to the highest level.
3. Disconnect the mains plug from the mains
power supply.
4. Allow the motor to cool down.
443223_a
Cause
Cutting blade is blocked.
Cables or switches are defec-
tive.
Cutting blade is blunt.
Too much grass in the ejector.
Cutting blade is blunt.
Motor is overloaded.
Grass is wet.
Grass catcher is clogged.
Too much grass in the dis-
charge channel or housing.
Cutting blade is blunt.
Cutting height is too low.
Cable insulation damaged.
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Remedy
■
Free the blade of obstructions.
■
Start the lawnmower on short grass.
Do not operate the appliance! Contact a
service centre of the manufacturer.
Have the cutting blade sharpened at one of
the manufacturer's service centres.
■
Remove the grass.
Clean the baffle.
■
Have the cutting blade sharpened at
one of the manufacturer's service cen-
tres.
Switch off the lawnmower, set it on level
ground or short grass and restart.
Allow the lawn to dry.
Clean the grid of the grass catcher.
■
Clean discharge channel / housing.
Correct the cutting height.
■
Have the cutting blade sharpened at
one of the manufacturer's service cen-
tres.
Increase the cutting height.
Do not operate the appliance! Contact a
service centre of the manufacturer.
5. Thoroughly clean the device.
6. Rub a thin coat of oil or silicon onto all metal
parts for corrosion protection.
7. Fold down the handlebar.
8. Store the appliance in a dry, clean location
protected from frost. Cover with a breathable
tarpaulin to protect against dust. Do not use
plastic film in order to avoid the accumulation
of moisture.
35