Tanning With Creams; Using The Appliance; First Use And Skin Test - Philips Lumea Essential SC1991 Bedienungsanleitung

ENGLISH
14
Tanning with artificial light
-
Follow the instructions in 'Sun exposure before treatment' and
'Sun exposure after treatment' above.

Tanning with creams

-
If you have used an artificial tanning lotion, wait until the artificial tan has
fully disappeared before you use Philips Lumea Essential.
Note: For more details on unwanted skin reactions, see chapter 'Using the
appliance', section 'Possible side effects and skin reactions'.

Using the appliance

Check the recommended light intensities table in chapter 'Preparing for
use', section 'Light intensity' to determine which light intensities are most
suitable for your skin and body hair colour.
Shave the area you intend to treat before you use the appliance (see
chapter 'Preparing for use', section 'Preparing treatment areas').
If the treatment becomes painful at any point in time, reduce the
light intensity setting until the treatment is comfortable again. If you
notice skin reactions stronger than slight redness, stop the treatment
immediately and read section 'Possible side effects and skin reactions' in
this chapter.

First use and skin test

When you use the appliance for the first time or after recent tanning, we
advise you to perform a skin test on each area to be treated to check
your skin's reaction to the treatment and to get accustomed to light-based
treatment.
1 Choose an area close to the area you intend to treat.
2 Insert the small plug into the appliance and put the adapter in the
wall socket.
Note: Make sure the body attachment is placed on the appliance.
3 Press the on/off button to switch on the appliance.
Intensity light 1 goes on.
,
Note: The appliance always automatically selects the lowest light intensity
setting. See section 'Light intensity' in chapter 'Preparing for use' to determine
the appropriate light intensity.
4 To adjust the light intensity setting, press the on/off button one
or more times until you have reached the required setting. The
corresponding intensity light lights up.