Maintenance; Maintenance And Greasing - Husqvarna BMH150 Bedienungsanweisung

Maintenance and greasing

After first 2 working hours all bolts and nuts must be tightened.
Greasing and maintenance should be done as mentioned in the table below.
a. Visual check
b. Clean / remove dirt
c. Check if bolts are correctly tightened
d. Grease nipple
Hitch
Daily -
Weekly -
Monthly d
Yearly a, b, c, d
Note: When cleaning the hydraulic cylinders do not use abrasive materials which can destroy the surface of
the cylinder.
The chain MUST be checked and lubrificated regularly with grease. Also remember to lubrificate the bearings
Due to several factors brushes might wear out unevenly.
For best performance and to avoid deterioration of other brushes we recommend changing a brush when it is
seriously damaged or it is worn out more than 30%.

Maintenance

Hydraulic Drum Bearing
Cylinders and transmision chain
a
-
b
a, b, d
Wheel supports
- a,b
- -
d d
- a, b, c, d
Brush Gearbox
a,b a
- b
- -
- -
– 9
English