Cleaning And Care; Disposal - Silvercrest HG05706A Bedienungs- Und Sicherheitshinweise

= 1. Remove any load from the weighing surface
, if any.
1
2. Set the product on a solid, level and flat surface.
3. Reset the product by holding the button UNIT
for approx. 3 seconds.
4. The product is re-calibrated and the whole
LC display
2
5. The numerical display
with the default unit.
6. You could place the item you wish to weigh
onto the product.
=
= The product is overloaded.
= 1. Remove the overload.
2. Reset the product by holding the button
UNIT for approx. 3 seconds.
4
3. The product is re-calibrated and the whole
LC display
2
4. The numerical display
with the default unit.
5. You could place the item you wish to weigh
onto the product.
Note: If is shown again, it means the overload is
greater than the max. measuring range. Remove the
overload.
will be shown for 2-3 seconds.
will read "0" again
7
will be shown for 2-3 seconds.
will read "0" again
7
Note: Be sure never to add more than 5 kg to the
weighing surface
damage it.
4
=
= The batteries are too weak to weigh. You cannot
operate the product.
= Replace the battery (see section "Replacing the
battery").
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be disrupted
by radio transmitting equipment in the immediate vicinity.
If the LC display
objects away from it.
Electrostatic discharges can lead to malfunctions. In
cases of the product failing to work, remove the
batteries for a short while and then replace them.

Cleaning and care

Never immerse the product in water or other
liquids. This can damage the product.
Clean the product with a slightly dampened, fluff-
free cloth. To remove more stubborn dirt, you can
also dampen the cloth with a weak soap solution.
You can remove leaked battery fluids with a dry,
absorbent cloth.

Disposal

The packaging is made entirely of recyclable materials,
which you may dispose of at local recycling facilities.
Observe the marking of the packaging
materials for waste separation, which are
b
a
marked with abbreviations (a) and numbers
(b) with following meaning: 1–7: plas-
. Overloading the product can
1
indicates a problem, move such
2
GB 11