Putting Into Operation; Connecting The Balance - Mettler Toledo XPR26PC Benutzerhandbuch

8 Slide the evaporation trap door (10) towards the back
until it snaps in on the rod (11).
9 Connect the light barrier cable (12) to the light barrier
(13).
10 Install the light barrier (13) on the light barrier spacer
(14) using the fixing screw (15).
Note
By default, the light barrier and the light barrier spacer are
installed on the right side of the pipetting base. Alterna-
tively, these items can be installed on the left side of the
pipetting base.
11 Guide the light barrier cable (12) along the side of the
balance, below the side cover.
12 Connect the light barrier cable (12) to one of the USB-A ports on the back side of the balance.
The balance is assembled and ready to be put into operation.

4.5 Putting into operation

4.5.1 Connecting the balance

Death or serious injury due to electric shock
Contact with parts that carry a live current can lead to death or injury.
1 Only use the METTLER TOLEDO power cable and AC/DC adapter designed for your
instrument.
2 Connect the power cable to a grounded power outlet.
3 Keep all electrical cables and connections away from liquids and moisture.
4 Check the cables and the power plug for damage and replace them if damaged.
1 Install the cables in such a way that they cannot be
damaged or interfere with operation.
2 Insert the plug of the AC/DC adapter (1) into the power
socket of the instrument.
3 Secure the plug by firmly tightening the knurled nut.
4 Insert the plug of the power cable into a grounded power
outlet that is easily accessible.
Note
Do not connect the instrument to a power outlet controlled by a switch. After switching on the instrument, it
must warm up before giving accurate results.
Pipette Calibration Balances
WARNING
11
10
1
14
13
12
15
13