Changing Engine Oil - Dometic ENERGY & LIGHTNING BLUTEC40D Montage- Und Bediensungsanleitung

CHANGING ENGINE OIL

Proceed as indicated.
1 -Turn the unit off.
2 -Leave the unit to cool
down sufficiently, to avoid
the risk of burning.
3 -Open the door (A).
4 -Provide a container of
sufficient capacity.
For the amounts of oil, see
"Technical data".
5 -Extract the dipstick (B).
6 -Unfasten the screw
(C) to extract the pump (D).
7 -Adjust the pump manually
to drain all the oil into the
container.
8 -Replace the pump (D) in
its housing and fix it with
the screw (C).
9 -Pour in the new oil until
reaching the correct level
on the dipstick (B) (see
"Check oil level").
10 -Replace the dipstick (B).
11 -Close the door (A) when
the operation has been
completed.
12 -Turn the unit on and
allow it to warm up for a
few minutes.
13 -Turn the unit off and
check the oil level (see
"Check oil level").
All manuals and user guides at all-guides.com
rod (B)
door (A)
pump (D)
Important
Do not discard used oil, but hand it over
to an authorised disposal organisation in
compliance with current local laws.
Use oils
recommended by the manufacturer.
- -
29
screw (C)
pump (D)
rod (B)
and lubricants of
GB
the types
User Manual