Philips DSR 1010 Betriebsanleitung Seite 31

All manuals and user guides at all-guides.com
Important remarks on location and assembly
Location
All electronic equipment generates heat, which is however not dangerous. Delicate
GB
furniture surfaces and finishes may become slightly discoloured over time due to the
permanent heat source. Likewise, the feet of the equipment may cause discolouring on
treated surfaces. If need be, place the unit on a suitable mat.
Ventilation
Heat occurring in this unit is discharged adequately. However, never install the receiver
in a cabinet or on a shelf where there is inadequate ventilation. Never cover the
ventilation slots of the unit.
Never place any objects on the unit and ensure that there is a space of at least 10 cm
above the unit to ensure that any heat occurring is discharged.
Humidity, sunlight, heat
Protect the unit from humidity, water droplets and spraying.
Do not locate the receiver in the vicinity of a heating source and avoid exposing it to
direct sunlight.
Electrical supply
Operate the unit only using a power source of 230 V/50 Hz. Connect the unit to the
power supply and switch on only after it has been connected to the antenna and
television unit.
Earth
Ensure that the parabolic antenna is correctly earthed observing the relevant local
and/or CE regulations.
Remote control
Insert the batteries supplied in the remote control. Ensure that the battery polarity is
correct observing the + and - markings in the battery compartment.
!