Installation - Sharp SJ-WX830A Bedienungsanleitung

Installation

1
Keep adequate ventilation space around the
refrigerator.
• The picture shows the minimum required space
for installing the refrigerator. The measurement
condition of energy consumption is conducted
90mm
60mm
1028mm
• By keeping greater space, the refrigerator may
consume a less amount of power consumption.
• If use the refrigerator in the smaller space
dimension than pictured above, it may cause
temperature rise in the unit, loud noise and failure.
SJ-WX830A,
SJ-SX830A
a 1440mm
b 1330mm
a
2
Use the two front the adjustable feet to place the
EN-3
50mm
846mm
SJ-PX830A
1432mm
1330mm
3
Use the adjustable feet when right and left doors are
not properly aligned.
When the left door are
raised.
Lower the foot
at right side.
• Turn the adjustable feet until the opposite foot is
4
Connect the appliance via a correctly installed socket.
Note
• Place your refrigerator to access the plug.
• Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
• Do not place your refrigerator directly on the ground.
Insert suitable stand such as wooden board under the
refrigerator.
• When you insert the power plug with the door opened,
door alarm sounds but it is normal. This sound stops
after closing the door.
• Do not push the refrigerator against the wall.
The wall surrounding the refrigerator may get dirty
radiation.
of the refrigerator
• The casters allow the refrigerator to
move back and forth.
• Clean the inside parts with a cloth soaked in warm
water.
•
with water.
Free standing type
When the right door are
raised.
Lower the foot
at left side.