Abicor Binzel BRS-FP Betriebsanleitung Seite 48

10 Troubleshooting
10.1 BRS-FP/BRS-FPi cleaning unit
Fault
Pneumatic motor does not run
Insufficient cleaning
Torch parts are damaged
No injection
Tab. 14 Troubleshooting BRS-FP/BRS-FPi
10.2 TSi injection unit for BRS-FPi
Fault
No injection
Too much/too little spray mist
Too little spray mist
No spray mist
Tab. 15
Troubleshooting for the injection unit
EN - 22
Cause
• Compressed air supply/hose
connection interrupted
• Directional valves Y1 or Y2 do not
switch
• Valve actuator does not move
• Reamer defective or blunt
• Wrong equipment parts
• Check the fill level
• Compressed air supply/hose
connections interrupted
• Directional valve of injection unit does
not open
• Valve actuator does not move
Cause
• Check the fill level
• Compressed air supply/hose
connection interrupted
• Mechanically operated injection
valve Y4 does not switch
• Anti-spatter fluid is empty
• Metering quantity incorrectly adjusted • Adjust the throttling screw
• Injection time too short
• Operating pressure too low
• Operating pressure too low
BRS-FP/BRS-FPi
Troubleshooting
• Check all supply lines leading to the
cylinder and threaded fittings
• Motor defective; replace
• Check the signal output of the robot
control
• Replace the directional valve
• Replace the reamer
• Check torch-dependent parts
• Check the immersion depth of the torch
• Top up the anti-spatter fluid
• Check all supply lines leading to the
cylinder and threaded fittings
• Check the signal output of the robot
control
• Replace the directional valve
Troubleshooting
• Top up the anti-spatter fluid
• Check all supply lines leading to the
cylinder and threaded fittings
• Replace mechanically operated injection
valve Y4
• Replace or refill bottle
• Check injection time (torch dwell time in
injection unit)
• Check the operating pressure
• Check the operating pressure
BAL.0028.0 • 2021-01-19