Dräger Polytron 6100 EC WL Gebrauchsanweisung Seite 57

Byte Bit Description
18 0 SIOS_DEVICE_ERROR
1 MEMORY_ERROR
2 FREQUENCY_CONTROL_ERROR
3 CURRENT_LIMITATION_ERROR
4 REFERENCE_ELECTRODE_ERROR
5 SDS_ERROR
6 SDS_LOAD_ERROR
7 SENSOR_HW_ERROR
19 0 PROFISAFE_TIMER_ERROR
1 BATTERY_CRITICAL
2 DEV_CONFIG_CHECK
20 0 WARMUP1
1 WARNING_SENSOR_SELFTEST
2 WARNING_OVERRANGE
3 WARNING_UNDERRANGE
4 WARNING_WRITE_EEPROM
5 ZERO_CAL_NECESSARY_FOR_SPAN
Instructions for use |
Dräger Polytron
Cause
Error in electronics.
Error in electronics.
Error in electronics.
Error in electronics.
Error in EC sensor.
Error in EC sensor.
Error in EC sensor.
Error in EC sensor.
Error in electronics.
Battery charge critical.
Error in electronics.
EC sensor in warm-up phase 1.
Sensor self-test failed for the first time.
Over range.
Under range.
Error in EC sensor.
Zero calibration not carried out yet.
®
6100 EC WL, Dräger Polytron
Remedy
Reset the sensor to the factory settings.
A Reset the sensor to the factory settings.
B Contact DrägerService.
A Reset the sensor to the factory settings.
B Contact DrägerService.
A Reset the sensor to the factory settings.
B Contact DrägerService.
Change the sensor.
Change the sensor.
Change the sensor.
Change the sensor.
A Reset the sensor to the factory settings.
B Contact DrägerService.
Change battery pack soon.
A Reset the sensor to the factory settings.
B Contact DrägerService.
Wait for warm-up phase 1 to finish.
Repeat sensor self-test.
–
Carrying out the zero calibration.
Remove sensor and insert it again.
Carrying out the zero calibration.
®
Repeater WirelessHART
|
Troubleshooting
®
en
57