Maintenance Schedule - Husqvarna Zenoah CHTZ2460 Bedienungsanweisung

Maintenance schedule

The following is a list of the maintenance steps that must be performed on the machine. Most of the items are described
in the Maintenance section. The user must only carry out the maintenance and service work described in this Operator's
Manual. More extensive work must be carried out by an authorized service workshop.
Maintenance
Clean the outside of the machine.
Make sure the throttle trigger lock and the throttle function
correctly from a safety point of view.
Check that the stop switch works correctly.
Check that the blades do not move when the engine is idling or
when the choke is in the start throttle position.
Check that the blades are undamaged and show no signs of
cracking or other damage. Replace the blades if necessary.
Check that the blade guard is not damaged or distorted. Replace
the blade guard if it is bent or damaged.
Clean the air filter. Replace if necessary.
Check that the hand guard is not damaged. Replace the guard if
damaged.
Check that nuts and screws are tight.
Check that there are no fuel leaks from the engine, tank or fuel
lines.
Check the starter and starter cord.
Check that the vibration damping elements are not damaged.
Clean the outside of the spark plug. Remove it and check the
electrode gap. Adjust the gap to 0,9-1,0 mm or replace the spark
plug. Check that the spark plug is fitted with a suppressor.
Clean the machine's cooling system.
Clean or replace the spark arrestor mesh on the muffler (only
applies to mufflers without a catalytic converter).
Clean the outside of the carburettor and the space around it.
Fill the gear housing with grease. This should be carried out
approximately every 60 working hours.
Check that the screws that hold the blades together are correctly
tightened.
Clean the fuel tank.
Check the fuel filter for contamination and the fuel hose for cracks
or other defects. Replace if necessary.
Check all cables and connections.
Check the clutch, clutch springs and the clutch drum for wear.
Replace if necessary by an autorized service workshop.
Replace the spark plug. Check that the spark plug is fitted with a
suppressor.
Check and clean the spark arrestor mesh on the muffler (only
applies to mufflers fitted with a catalytic converter).
To reduce the fire hazard, clean dirt, leaves and surplus lubricant,
etc from the muffler and engine.
MAINTENANCE
Daily
maintenance
X
X
X
X
X
X
X
X
X
X
Weekly Monthly
maintenance maintenance
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
English – 19