Haier HW80-B14266A Benutzerhandbuch Seite 23

Installation
Preparation
Remove all packaging material including polystyrene base.
While opening the package, water drops may be seen on
plastic bag and porthole. This normal phenomenon results
from water tests in the factory.
Dispose of the packaging in an environmentally
friendly manner. For information refering current
disposal routes, consult your retailer or the local
authorities.
Optional: Adjusting the bottom cover
board
When opening the shrink package, you will find a calcium-
plastic board and a felt. The board is used for reducing
noise after covering the bottom of the cabinet.
1. Past the felt on one side of the calcium-plastic board
(figure.1).
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator and
screw off the four bolts. (figure 2).
3. Place the calcium-plastic board with felt towards inside,
screw the bolts through the four holes on the board
on to the tub firmly (figure 3). Finally set the machine
upright again.
Dismantle the transportation bolts
The transportation bolts are designed for clamping anti-
vibration components inside the appliance during trans-
portation to prevent inner damage.
4. Remove the back cover.
5. Remove bolts on the rear side and take out
from inner side of the machine.
spacers (A)
General information and tips:
Keep the transportation bolts in a safe place for later
use. Whenever the appliance is to be moved at first
reinstall the bolts.
1.
2
.
3.
plastic
23
4
.
5.
A