In Case Of Power Failure - Haier HW80-B14266A Benutzerhandbuch

22
Problem
Operation stops
before completing
wash cycle
Operation stops for a
period of time
Excessive foam floats
drum and/or deter-
gent drawer.
Automatic adjustment
of washing time.
Spinning fails.
General information and tips:
If too much foam is inspected during spin cycle, motor stops and drain pump will be
activated for 90 seconds. If that elimination of foam fails up to 3 times, programme
ends without spinning.
Warning!
Electrical equipment should be serviced only by qualified electrical experts, because improper
repairs can cause considerable consequential damages.
If the supply cord is damaged, it must be replaced by the service agent (see warranty card) in
order to avoid a hazard.
lever
Cause
Water or electric failure.
Appliance displays error code.
Problem due to load pattern.
Programme performs soaking
cycle?
Detergent is not a appropriate
Excessive use of detergent.
Washing programme duration
will be adjusted.
Unbalance of laundry.

In case of power failure

The current programme and its setting will be saved. When
power supply is restored operation will be resumed. To can-
cel it, touch "Start/Pause" and then "Power" for about 3 sec.
If a power failure cuts an operating wash programme door
opening is mechanically blocked. To get out any laundry water
level should not be seen in the glassy porthole of the door. -
Danger of burns! Water level has to be lowered as described
in "Pump filter". Not till then pull lever beneath service flap
until door is unlocked by a gentle click. Afterwards refix all
parts.
Troubleshooting
Solution
Check power and water supply
Consider error code
Reduce or adjust load.
If it seems appropriate cancel
operation.
Check detergent recommen-
dations.
Reduce amount of detergent.
This is normal and doesn't
affect functionality.
Check machine load and
laundry and run a spinning
programme again.