Installing The Battery Pack - Toro Power Plex 51138 Bedienungsanleitung

7. Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light Right Light
Red
Off
Red Red
Green Red
Orange Red
Red Blinking Red

Installing the Battery Pack

1. Set the chain saw down on a level surface.
2. Align the tongue of the battery pack with the
battery cavity in the chain saw
3. Push the battery pack into the battery cavity until
the battery pack locks into place.
Indicates:
Charger is on; no battery
pack inserted
Battery pack is charging
Battery pack is charged
Battery pack is too warm
Battery pack is defective
(Figure
Figure 25
25).
g192108
16