Casselin CLVAD Serie Handbuch Seite 32

How to proceed
Machine conditions: Machine off (lack of power supply), door open.
Set the DIP switches to select the number of cycles for regeneration warning.
See table
Counting disabled
ON
OFF OFF OFF OFF
60 Cycles
ON
OFF
80 Cycles
ON
OFF
100 Cycles
ON
OFF
After setting the DIP switches, supply power to the machine while continuing to press button A-2.
Wait for the cycle LED (A-5) to go out and then release button A-2. The programmed cycle is then stored.
If necessary, it can be modified during the programming phase, using the DIP switches.
Return DIP switch to original state. After these settings, wait a second and turn off the power.
The number of cycles is incremented at each cycle start ; when the programmed number of cycles is
reached, it can only be stopped by starting the regeneration cycle.
45 Cycles
ON
65 Cycles
ON
OFF
85 Cycles
ON
OFF
105 Cycles
ON
OFF
50 Cycles
ON
70 Cycles
ON
OFF
90 Cycles
ON
OFF
110 Cycles
ON
OFF
55 Cycles
ON
75 Cycles
ON
OFF
95 Cycles
ON
OFF
115 Cycles
ON
OFF
EN