Adjusting The Quick Shoot Control - Toro CCR Quick Clear 6053 Bedienungsanleitung

Note:
Route the new drive belt first around the
engine pulley, then the idler pulley, and finally
around the loose rotor pulley positioned just
above the rotor shaft
6. Install the rotor pulley onto the rotor shaft
28).
7. Install the curved washer and the rotor-pulley
bolt and tighten them securely
Note:
The concave side of the curved washer
goes against the outside of the pulley.
8. Install the brake spring onto the idler arm
29).
9. Install the drive-belt cover with the bolts that you
removed in step 1.
Note:
Ensure that the drive belt is properly
adjusted and operating; refer to
Control Cable (page 13)
Control Cable (page
Adjusting the Quick Shoot
Control
If there is more than 13 mm (1/2 inch) of slack in the
Quick Shoot cable (Figure
does not rotate left and right in equal angles, adjust
the Quick Shoot control cables.
1. 13 mm (1/2 inch) maximum slack
1. Loosen the 2 Quick Shoot control-cable clamps
(Figure 31).
(Figure 28).
(Figure
Checking the
and Adjusting the
14).
30) or the discharge chute
Figure 30
(Figure
28).
(Figure
1. Cable clamps
2. Position the Quick Shoot control between the
2 arrows located on the right side of the upper
handle
1. Arrows
3. Rotate the discharge chute so that it faces
straight ahead and the arrow on the back of the
discharge chute aligns with the arrow on the
shroud
g006514
18
Figure 31
(Figure 32).
Figure 32
(Figure 33).
g006406
g006405