Inserting/Changing The Battery - Bosch Atino Originalbetriebsanleitung

Line laser
Levelling accuracy of visible laser line
Length of tape measure
Tape measure measuring accuracy
Tape measure accuracy class
Operating temperature
Storage temperature
Max. altitude
Relative air humidity max.
Pollution degree according to IEC 61010-1
Laser class
Laser type
C
6
Divergence
Battery
Operating time at least
Weight according to EPTA-Procedure 01:2014
Dimensions (length × width × height)
A) depending on surface characteristics and ambient conditions
B) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
The serial number (9) on the type plate is used to clearly identify your measuring tool.
Assembly

Inserting/Changing the Battery

It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
Do not use lithium-ion batteries. This may result in damage to the measuring tool.
u
To open the battery compartment cover (5), press on the locking mechanism (6) and re-
move the battery compartment cover. Insert the battery.
When inserting the batteries, ensure that the polarity is correct according to the illustra-
tion on the inside of the battery compartment.
Bosch Power Tools
English | 19
Atino
±0.3°
1.5 m
±2 mm/m
+5 °C to +40 °C
–20 °C to +70 °C
2000 m
90 %
2
630–650 nm, < 5 mW
15 × 15 mrad (full angle)
1 × 1.5 V LR6 (AA)
5 h
0.26 kg
124 × 115 × 62 mm
1 609 92A 55E | (12.05.2020)
Ⅱ
B)
2
5