Bosch PSR 10,8 LI Originalbetriebsanleitung Seite 32

OBJ_BUCH-1400-003.book Page 32 Tuesday, June 18, 2013 9:33 AM
32 | English
Note: The battery is supplied partially charged. To ensure full capacity of
the battery, completely charge the battery in the battery charger before
using your power tool for the first time.
The lithium ion battery can be charged at any time without reducing its ser-
vice life. Interrupting the charging procedure does not damage the battery.
The Lithium-Ion battery is protected against deep discharging by the
"Electronic Cell Protection (ECP)". When the battery is empty, the ma-
chine is switched off by means of a protective circuit: The inserted tool no
longer rotates.
 Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this manner.
The charging procedure begins as soon as the mains plug of the battery
charger is plugged into a socket outlet and the charge connector 12 is
plugged into the socket 11 on the bottom of the handle.
The battery charge-control indicator 5 indicates the charging progress.
During the charging process, the indicator flashes green. When the bat-
tery charge-control indicator 5 lights up green continuously, the battery
is fully charged.
During the charging procedure, the handle of the machine warms up. This
is normal.
Disconnect the battery charger from the mains supply when not using it
for longer periods.
The power tool cannot be used during the charge procedure; it is not de-
fective when inoperative during the charging procedure.
Observe the notes for disposal.
Changing the Tool (see figure B)
 Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational di-
rection switch to the centre position. Unintentional actuation of the
On/Off switch can lead to injuries.
The drill spindle is locked when the On/Off switch 8 is not pressed. This
makes quick, convenient and easy changing of the tool in the drill chuck
possible.
1 609 92A 0A0 | (18.6.13) Bosch Power Tools