Disposal Of Packaging Materials; Charging The Power Bank - Silvercrest SPB 5200 A1 Bedienungsanleitung Und Sicherheitshinweise

Downloaded from www.Manualslib.com

Disposal of packaging materials

The packaging protects the device from damage
during transport. The packaging materials have
been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
Returning the packaging into the material cycle conserves
raw materials and reduces the amount of waste generated.
Dispose of packaging materials that are no longer needed in
accordance with applicable local regulations.

Charging the Power Bank

Before using the Power Bank, the integrated battery must be
fully charged. The required charging time for the Power Bank
is dependent of the charging source and its output (max.
5 V/1 A).
CAUTION!
► Only use mains adapters with an output voltage of 5 V
and an output current of at least 1 A or a USB 3.0 port
on your computer to charge the Power Bank. You can
recognise the USB 3.0 port due to the blue marking.
► When charging via a USB port, ensure that at least one
further USB port remains free. This also applies when
using USB 3.0 ports.
Option A
♦ Connect the USB plug
PC or a USB power supply (not supplied). The current charge
level is shown during charging by means of the charge level
LEDs :
LED display
One LED is flashing
One LED is on, the second LED is flashing
Two LEDs are on, the third LED is flashing
Three LEDs are on, the fourth LED is flashing
All LEDs are on
■ 6 │ GB │ CY
manuals search engine
of the Power Bank to a switched-on
Charge
25–49%
50–74%
75–99%
SPB 5200 A1
level
< 25%
100%