Parts And Operating Controls; Before Using For The First Time; Boiling Water - Siemens TW86 Serie Gebrauchsanleitung

en
Congratulations on purchasing this
Siemens appliance. You have acquired
a high-quality product that will bring
you a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid
3 Lid release button
4 ON/OFF O switch
5 Temperature indicator (illuminated)
6 + – button (temperature setting)
7 U button (keep warm)
8 Limescale filter (removable)
9 Base
10 Cable tidy
Important: Use the kettle 1 only with its
included base 9.
● Only fill the kettle with water. Milk and
instant beverages will burn and damage
the appliance. Never operate the kettle
1 without water and do not overfill it;
observe the min and max markings.
If the kettle is too full, the water will boil
over!
Before using
for the first time
● Remove any stickers or film.
● Unroll the right amount of cable from the
cable tidy 10 and plug it in.
● Fill the kettle 1 with water. Bring the water
to a boil and discard it. Repeat the proce-
dure. This will make sure that the kettle is
clean for normal use.
● When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
8

Boiling water

● Fill the kettle with fresh water through the
spout or the open lid 2 (press lid release
button 3).
● Check the amount by reading the water
level indicator markings (min and max).
● Close the lid 2 until it locks and place the
kettle 1 on the base 9.
● Press the O ON/OFF switch 4. The
kettle emits a signal, and the factory-set
temperature (100°C) lights up. The water
is being heated.
● By pressing button 6 + or – you can set
the temperature to ca. 70°C, ca. 80°C,
ca. 90°C or ca. 100°C.
● When the water has reached the selected
temperature, the kettle will switch off
automatically, the temperature indicator 5
goes off, and a signal sounds.
Note: The selected temperature can be
changed at any time while the kettle is
heating up. While the kettle heats up, the
current temperature lights up; the preset
temperature flashes until it has been
reached.
If the temperature cannot be set, this indi-
cates that the water in the kettle is hotter
than the desired temperature. The current
temperature will light up.
You can turn off the kettle at any time by
pressing the O ON/OFF switch 4 again.
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water. The selected settings will
be lost (reset to factory setting).