Safety; General Information And Notes For The Reader; Intended Use; Improper Use - ABB CoriolisMaster serie Inbetriebnahmeanleitung

1

Safety

Change from one to two columns
1.1

General information and notes for the reader

You must read these instructions carefully prior to installing
and commissioning the device.
These instructions are an important part of the product and
must be kept for future reference.
These instructions are intended as an overview and do not
contain detailed information on all designs for this product or
every possible aspect of installation, operation and
maintenance.
For additional information or if specific problems occur that
are not discussed in these instructions, contact the
manufacturer.
The content of these instructions is neither part of any
previous or existing agreement, promise or legal relationship
nor is it intended to change the same.
This product is built based on state-of-the-art technology and
is operationally safe. It has been tested and left the factory in
perfect working order from a safety perspective. The
information in the manual must be observed and followed in
order to maintain this state throughout the period of operation.
Modifications and repairs to the product may only be
performed if expressly permitted by these instructions.
Only by observing all of the safety instructions and all
safety / warning symbols in these instructions can optimum
protection of both personnel and the environment, as well as
safe and fault-free operation of the device, be ensured.
Information and symbols directly on the product must be
observed. They may not be removed and must be fully legible
at all times.
4 - EN CI/FCB300-X1 | CoriolisMaster FCB330, FCB350
1.2

Intended use

This device is intended for the following uses:
— To convey liquids and gases (including unstable liquids and
gases)
— To meter mass flow directly
— To meter volumetric flow (indirectly via mass flow and
density)
— To measure the density of the liquid or gas
— To measure the temperature of the liquid or gas
Using these products as intended involves observing the
following points:
— Read and follow the instructions in this manual
— Observe the technical ratings (refer to the "Technical limit
values" section)
— Use only approved media for measurement (refer to the
"Permissible media for measurement" section)
1.3

Improper use

The following are considered to be instances of improper use
of the device:
— Operation as a flexible adapter in piping, e.g., to
compensate for pipe offsets, pipe vibrations, pipe
expansions, etc.
— Use as a climbing aid, e.g., for mounting purposes
— Use as a support for external loads, e.g., as a support for
piping, etc.
— Addition of material, e.g., by painting over the name plate
or welding/soldering on parts
— Removal of material, e.g., by spot drilling the housing
1.4

Target groups and qualifications

Installation, commissioning and maintenance of the product
may only be performed by trained specialist personnel who
have been authorized by the plant operator to do so. The
specialist personnel must have read and understood the
manual and comply with its instructions.
The operators must strictly observe the applicable national
regulations with regards to installation, function tests, repairs,
and maintenance of electrical products.