Preparation; Required Tools And Materials - LIVARNO LUX IAN 306755 Montage-, Bedienungs- Und Sicherheitshinweise

LIFE AND RISK OF ACCIDENT
FOR INFANTS AND CHILDREN!
Never leave children alone and unsupervised
with the packaging material. The packaging
material poses a suffocation hazard. Children
frequently underestimate the dangers. Always
keep children away from the product.
This product is not a toy and should be kept
out of the reach of children. Children cannot
recognise the risks associated with the use of
the product.
This product may be used by children aged
8 years and up, as well as by persons with re-
duced physical, sensory or mental capacities,
or lacking experience and knowledge, so long
as they are supervised or instructed in the safe
use of the product and understand the associ-
ated risks. Do not allow children to play with
the product. Cleaning and user maintenance
must not be performed by children without su-
pervision.
Avoid the risk of fatal injury
from electric shock
Have the electrical installation performed by
an electrician or a person trained in electrical
installation.
Never use the light if you detect any damage.
Remove the fuse or switch off the circuit breaker
(0 setting) in the fuse box prior to installation.
Prior to installation, verify the mains voltage on
site corresponds with the operating voltage
required for the light (220–240 V∼, 50 Hz).
Never open the housing of the light or insert
any objects into it. This will pose the risk of
fatal injury from electric shock.
Only insert insert lamps of the correct type
and do not exceed the maximum lamp output
(max. 20 W LED).
A broken lamp glass must be imme-
diately replaced with a new one.
Please contact the service centre
to do so.
Only parts provided by the manufacturer may
be used.
8 GB/IE/NI
DANGER TO
The tools and materials specified are not included.
This information and values specified are non-bind-
ing and are only provided as a reference. The na-
ture of the material is determined by the individual
local conditions.
Replace defective lamps when they have
cooled down.
Do not install the light on a wet or conductive
surface!
Prevent fire and
injury hazards
CAUTION! RISK OF BURNS
DUE TO HOT SURFACES! Verify
the light has been switched off and
has cooled down before touching it to avoid
burns. Light bulbs can become very hot.
When the light is in operation, individual parts
may become hot. Allow the light to cool down
completely before performing any work.
Do not carelessly leave the light or packaging
material lying around. Plastic film / bags, plastic
parts, etc. are dangerous for children to play
with.
To prevent a fire hazard do not operate the
light in its packaging.
Do not cover the light with objects. Excessive
heat build-up can result in fire.
For your safety
Prepare the installation with care and allow
sufficient time. First organise all parts or
materials so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and always proceed with
caution.
Never install the light if you are having diffi-
culty concentrating or do not feel well.

Preparation

Required tools and materials