Set The Angle Of The Wall-Mount Bracket - Sharp AQUOS AN-65AG1 Bedienungsanleitung

Set the angle of the wall-mount bracket

• Please perform this work before mounting the Liquid Crystal Television on the wall.
Caution
• When setting the angle of the wall-mount bracket, be careful not to pinch your fingers, etc.
■
The LC-65GE1 (Separate type) is used as an example for the following explanation. The procedure is the same
for the LC-65D90U (Integrated type).
Remove the vertical positioning screws from the wall-mount bracket (2 screws each on
1
the left and right sides).
Assemble the included angle setup brackets as shown in the illustration and then use
2
them to set the TV to the desired angle.
For the screws, use the included angle setup bracket screws (M8 length: 15 mm × 2 screws)
and screws removed in Step 1.
First loosely tighten the 4 screws and then securely tighten them after the angle setup bracket
is set to the desired position.
Hole at the very top
Included part
Angle setup bracket screws
Angle setup bracket
These screws are used for the angle
setup in Step 2.
The numbers 5, 10, 15, and 20 at the
screw holes mean that the higher the
number, the more the Liquid Crystal
Television slants downward. The
angle that can be set is limited
depending on the TV model.
M8 length:
15mm (2 screws)
E-9