Dmx Linking; Dmx Connection - Chauvet Professional STRIKE SABER Schnellanleitung

DMX Linking

The STRIKE Saber will work with a DMX controller using a 5-pin DMX data connection. A DMX Primer is available from
www.chauvetprofessional.com.

DMX Connection

The STRIKE Saber uses a 5-pin DMX data connection for its DMX personalities: 3Ch, 5Ch, 6Ch, 8Ch, 9Ch, 21Ch, and
27Ch. See the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The STRIKE Saber uses the DMX data connection for its Master/Slave mode. See the User Manual for information about
connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The STRIKE Saber supports RDM protocol that allows feedback to monitor changes to DMX
Address, DMX Channel, Dimmer Mode, and LED Frequency menu options. Download the User Manual from
www.chauvetprofessional.com
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting
clamps, go to http://trusst.com/products.
Floor Stand
The STRIKE Saber comes with a Floor Stand which can be installed with the included screws.
Mounting Diagram
Overhead Mounting
Safety Cable
Secure the safety
cable using the
passageway on
the back of the
product
Floor Stand Installation
STRIKE Saber QRG Rev. 1
QUICK REFERENCE GUIDE
for more details.
Safety Notes. Use at least one mounting point per product. Make sure the
Insert included screws (x4)
Mounting Clamp
EN
2