Introduction; Proper Use; Features And Equipment - Parkside PTBM 500 Bedienungs- Und Sicherheitshinweise

Introduction

The following icons / symbols are used in this instruction manual:
Read instruction manual!
Observe caution and safety notes!
Caution – electric shock!
Dangerous electric current – danger
to life!
Explosive material!
V ~
Voltage
W
Watts (Effective power)
Bench press drill PTBM 500
Introduction
Q
Please make sure you familiarise your-
self fully with the way the device works
before you use it for the first time and
that you understand how to handle electrical pow-
er tools correctly. To help you do this please read
the accompanying operating instructions. Keep
these instructions in a safe place. If you pass the
device on to anyone else, please ensure that you
also pass on all the documentation.

Proper use

Q
This device is intended for drilling in metal, wood,
plastic and tiles using parallel-shank drill bits
(ø 1.5 mm to a maximum ø 16 mm). Any other use
or modification to the device shall be considered
as improper use and could give rise to considera-
ble risk of accident. We will not accept liability for
loss or damage arising from improper use. The de-
vice is intended for domestic use only.
26 GB/MT
E-3470_Table_Drill_PTBM500_Content_LB5.indd 26
Wear dust protection mask, protective
glasses and protective gloves.
Keep children and other unauthorised
personnel at a safe distance when
using electrical tools.
Keep the device away from rain or
moisture. Water entering an electrical
device increases the risk of electric
shock.
Damaged appliances, power cables
and power plugs mean potentially fa-
tal risks from electric shock. Regularly
check the condition of the appliance,
the power cables and the power plugs.
Dispose packaging and appliance in
an environmentally-friendly way!

Features and equipment

Q
OFF switch
1
ON switch
2
Chuck
3
Drill spindle
4
5 Guard
Drive / belt cover
6
Handle/spindle guide with 3 drill lifting arms
7
Fixing screw for presetting drilling depth
8
Chuck key holder
9
Drive / belt cover locking screw
10
Fixing screw (both sides)
11
Depth stop with scale
12
Vice
13
Jaws
14
Angle scale
15
Clamp bolt
16
3 mounting bolts
17
a 3 flat washers
17
b 3 Retaining rings
17
Base plate
18
Drilling table
19
2 vice bolts
20
a 4 flat washers
20
b 2 nuts
20
Clamping bolt
21
17.03.2008 16:23:03 Uhr