Kenwood HM-L700 Bedienungsanleitung Seite 42

CD player section
Symptom
The CD is not drawn into the CD player.
A CD is placed in the player but it cannot be
played.
Sound is not produced.
Sound skips.
The display does not switch when the DIS-
PLAY key is pressed.
Remote control unit
Symptom
Remote control operation is not possible.
Displayed messages and actions to be taken against them
Displayed Message
CHECK DISC
PGM FULL
READING
TEXT FULL
42
EN
÷ Insert the CD into the center of the CD slot.
÷ This component stereo optical scans CDs to read content, there-
fore transparent CDs cannot be used with it.
÷ Place the disc properly, with the label side facing the front.
÷ Clean the disc referring to "Disc handling precautions". ‚
÷ Refer to "Caution on condensation" and remove the condensa-
tion by evaporation.
÷ Press the CD 6 key.
÷ Clean the disc referring to "Disc handling precautions". ‚
÷ Clean the disc referring to "Disc handling precautions". ‚
÷ Install the unit in a place not subject to vibrations.
÷ The display content does not change while "CHECK DISC" ap-
pears on the display. See "Displayed messages and action to be
taken against them" below.
÷ Replace with a new battery.
÷ Operate the unit inside the remote controllable range.
÷ TOC (table of contents) information could not be read.
÷ The disc is not properly loaded.
÷ An attempt is made to select a 33rd track during programing of CD. Only up to 32
tracks can be programmed.
÷ TOC (table of contents) information is being read.
÷ The CD player is trying to display text information of a CD-TEXT disc that contains
more than 1,536 byte of text information.
Remedy
Remedy
Meaning
In case of difficulty
&
·
#
#