AL-KO CLASSIC Betriebsanleitung Seite 28

en
Manual starting
Without speed remote control, with choke
Choke *
Start
1 Set choke to position 1 (13/1).
2 Pull the safety bar to the upper bar and hold
(17) – safety bar does not engage.
3 Pull the starter cord quickly and allow it to
slowly coil up again (18).
4 After the motor has warmed up (approx.
15-20 seconds), set the choke position 2
( 13/2).
The motor has a fixed speed setting. A
speed regulation is not possible.
Without speed remote control, with primer
(16)
1 Press the primer button 3x, at intervals of ap-
prox. 2 seconds (16). At temperatures below
10 °C, press the primer button 5x.
2 Pull the safety bar to the upper bar and hold
(17) – safety bar does not engage.
3 Pull the starter cord quickly and allow it to
slowly coil up again (18).
The motor has a fixed speed setting. A
speed regulation is not possible.
Without speed remote control, without pri-
mer/choke
1 Pull the safety bar to the upper bar and hold
(17) – safety bar does not engage.
2 Pull the starter cord quickly and allow it to
slowly coil up again (18).
The motor has a fixed speed setting. A
speed regulation is not possible.
With speed remote control, with choke
Speed re-
mote con-
trol, with
choke *
28
Run Stop
1
Set speed lever to position
2 Pull the safety bar to the upper bar and hold
(17) – safety bar does not engage.
3 Pull the starter cord quickly and allow it to
slowly coil up again (18).
4 After the motor has warmed up (approx.
15-20 seconds) set the gas lever to a position
between and
With speed remote control, without pri-
mer/choke
Speed re-
mote con-
trol *
Start
1
Set speed lever to position
2 Pull the safety bar to the upper bar and hold
(17) - safety bar does not engage.
3 Pull the starter cord quickly and allow it to
slowly coil up again (18).
4 After the motor has warmed up (approx.
15-20 seconds) set the speed lever to a po-
sition between
With speed remote control, with primer (16)
Speed re-
mote con-
trol *
Start
1
Set speed lever to position
2 Press the primer button 3x, at intervals of ap-
prox. 2 seconds (16). At temperatures below
10 °C, press the primer button 5x.
3 Pull the safety bar to the upper bar and hold
(17) - safety bar does not engage.
4 Pull the starter cord quickly and allow it to
slowly coil up again (18).
5 As soon as the motor is running, set the
speed lever for the desired motor speed to a
position between
Startup
(14/1).
(14/2).
Stop
(20/1).
and (20).
Stop
(20/1).
und (20).
469378_d