AL-KO CLASSIC Betriebsanleitung Seite 27

Startup
Inserting the side discharge
1. Remove the grass catcher and insert the
mulch kit.
2. Fold open the cover for the side discharge
and hold firmly (11/1).
3. Insert the side discharge chute (11/2).
4. Slowly close the cover.
The cover secures the side discharge
channel from falling out.
Removing the side discharge
1. Fold open the cover for the side discharge
and hold firmly (11/1).
2. Remove the side discharge and close the co-
ver (11/2).
Working height adjustment (option)
The working height can be adjusted to two diffe-
rent heights, if needed.
1 An der Unterholmverschraubung die beiden
Griffschrauben abdrehen.
2 Pull out the threaded bolts and adjust to the
desired position by inserting into one of the
two square holes on the holders and through
the bars (12).
Make sure that the same hole is used on each
of the holders!
3 Tighten the holders with the lower bar again
using the handle screws.
Starting the motor
WARNING!
Never leave an engine running in an en-
closed space. Toxic hazard!
CAUTION!
Risk of injury due to rotating parts!
Do not tip the unit during the starting pro-
cedure!
Only start the motor with mounted
blade (the blade serves as centrifu-
gal mass)!
When starting the warmed motor, do
NOT use the (HONDA) choke or pri-
mer button!
Do not modify the control settings on
the motor!
469378_d
Individual wheel quick adjustment or axle ad-
justment (4)
To unlock, press the lever to the side and
hold.
Slide the lever to the left or right in the desired
cutting height.
Allow the lever to engage.
Make sure all wheels engage at the same po-
sition.
Do not start the unit if the discharge chute is
not covered by one of the following parts:
Grass catcher
Baffle plate
Mulch kit
Operate the starter switch with particular care
according to the manufacturer instructions.
Make sure your feet are at a sufficient dis-
tance away from the cutter unit.
Start the unit in low grass.
Position indicators on the unit
Choke *
Start
Speed re-
mote con-
trol *
Start
Speed re-
mote con-
trol, with
choke *
Vario gear-
box *
Fast
Blade
clutch *
On
* depending on version
Run Stop
Stop
Slow
Off
27