Draining The Water Tank; Cleaning The Evaporator - Beko DS 7536 MM Bedienungsanleitung

• Clean metal surfaces of the sensors 4
times a year.
• Do not use metal tools when cleaning
metal surfaces of the sensors.
A
WARNING!
• Never use solvents, cleaning agents or
similar substances for cleaning due to the
risk of fire and explosion!

6.3 Draining the water tank

Dampness of the laundry is removed and
condensed during drying process and the
water that arise accumulates in the water tank.
Drain the water tank after each drying cycle.
A
WARNING!
• Condensed water is not drinkable!
• Never remove the water tank when the
program is running!
If you forget to drain the water tank, the
machine will stop during the subsequent drying
cycles when the water tank is full and the Water
Tank warning symbol will flash. If this is the
case, drain the water tank and press Start /
Pause button to resume the drying cycle.
To drain the water tank:
1. Remove the water tank in the drawer
or container carefully.
2. Drain the water in the tank.
• If there is lint accumulation in the funnel
of the water tank, clean it under running
water.
• Place the water tank into its seat.
44
C
NOTE
• If the direct water draining is used as an
option, there is no need to empty the
water tank.

6.4 Cleaning the evaporator

The hair and fibres that are not caught by the
fibre filter goes to the fins of the evaporator
behind the toe board and accumulates here.
If the evaporator"
month periods, clean the evaporator.
" icon is flashing or in 6
• Open the toe
board by pressing
on it.
• To open the air
routing door, move
the release latch.
• Clean the fibres
on the evaporator
with a damp cloth
/ vacuum cleaner
with a brush by
moving upwards
and downwards.
• After the cleaning
process is
completed, place
the air router door
to its place, move
the latches to close
it and close the toe
board.
Dryer / User Manual