Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.6
Preassembling the lubricating oil
return hose
Procedure:
¶
Push the two hose manifolds (Fig. 12, Pos. 1) into
the transparent PVC hose (Fig. 12, Pos. 3) and secu-
re with the hose clamps (Fig. 12, Pos. 2).
1
2
3
Fig. 12:
Return hose for lubricating oil
3.7
Fitting the edge protector to
the KMA
Procedure:
¶
Press the edge protector (Fig. 13, Pos. 1) onto the
edge of the oil pan of the KMA.
1
Fig. 13:
Edge protector
Robert Bosch GmbH
3.8
i
Procedure:
2
1
1. Clean and grease the adhesive surfaces of the
2. Detach the adhesive labels (Fig. 14, Pos. 1) from the
458823_23pa
3. Detach the adhesive labels (Fig. 14, Pos. 4) from the
Fig. 14:
Structure | CAM 847 | 25
Affixing the adhesive labels
If you are using the CRI 846/CRI 846H tester set,
the adhesive labels are already affixed to the KMA
and the heat exchanger. In this case, please skip this
section.
heat exchanger and KMA with a suitable product
(e. g. spirit).
film and affix to the heat exchanger (Fig. 14, Pos. 2).
film and affix to the front cover of the KMA testing de-
vice (Fig. 14, Pos. 3).
1. 1
2. 1
2.2 3. 1
3.2 4. 1
1
2
3
1
2
3
4
5
6
DIESEL FUEL
KMA and heat exchanger
en
1
5.2
6.2
4.2
2
6
4
5
7
8
9
10 11 12
3
4
|
1 689 978 508
2011-12-03
Werbung
Inhaltsverzeichnis
