VOLTOMAT HEATING GR-107937.4 Bedienungsanleitung Seite 72

This unit has a remote control. One piece of CR2025 battery is to be installed. The functions of the remote
control buttons are the same as of the touch buttons on the control panel.
Please align the remote control to the remote control receiver on the unit; the remote control will not work if
the receiver is blocked.
OPERATION
Plug the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power switch. A
beep sound will be heard. The appliance is standby. The digital display shows the current ambient temperature.
Please press the buttons on the remote control or touch the buttons on the control panel to choose your
desired function.
The appliance may emit some smoke and a characteristic smell when you switch it on for the first time. This is
normal and will stop soon.
1. On/off button
Press the on/off button once to turn on the heater. The digital display shows the room temperature. Press it
one more time, the heater will be turned off. The heater will be put into a standby mode.
2. Temperature button
The default set temperature is 25°C when the appliance is turned on. Press the temperature button to set your
desired room temperature from 16°C to 40°C. Heater will be in effect after 5 seconds. The temperature
function will be conserved before shut down and the appliance will work with the same set temperature after
turned on again under standby mode.
Please note: The heater will turn off the heating element automatically once the ambient temperature (room
temperature) reaches the set temperature. The heater will be turned on automatically when the ambient
temperature falls below the set temperature.
3. Power button
You can press the power button to switch the power settings between low power & high power. Under each
mode, the power input is different, so please refer to the power input data from following table.
Power input
Low power 1000W
High power 2000W
4. Timer button
Press the timer button to set your desired working time from 1h to 24h. It will be in effect after 5 seconds.
Please note no operation display will be shown on the control panel. If you do not set the timer, the heater will
work continuously with no time limit.
5. Child lock button
Touch the child lock button on the control panel for three seconds or press the child lock button on the remote
control or to lock / unlock your heater. When appliance is under lock condition, heater will not work by
pressing any buttons until you unlock manually.
SAFETY SYSTEM
The appliance has a safety system which automatically switches the unit off when overheated.
- 71 -