Cleaning And Maintenance; Replacing The Filter; Troubleshooting - Silvercrest SDB 1500 A1 Bedienungs- Und Sicherheitshinweise

Press the handle
it clicks into place (Fig. M).
Place the motor body
(Fig. N).
ATTENTION! The hinge between the steam
base and motor body
9
place to ensure that the device can stand
upright in a stable fashion.

Cleaning and Maintenance

ATTENTION! Unplug the mains plug
the socket before cleaning the device. Allow
the device to cool for several minutes before
cleaning.
ATTENTION! Never immerse the device in
water or other liquids! Risk of electric shock/
short circuit.
ATTENTION! Check the condition of the
mains cable after each use. If this should
4
become damaged, take it to an appropriate
service centre to be replaced by a specialist.
Do not use any abrasives and/or solvents for
cleaning the device as this could damage the
plastic parts.
Do not fill any vinegar, descaling agents or
other perfumed substances into the tank. Doing
so will void the guarantee.
Clean the plastic parts on the device with a
damp, non-abrasive cloth and dry it with a dry,
non-abrasive cloth.
Rinse out the water tank from time to time with
fresh water and empty it thereafter.
Wash the washable pad
tions on the label.
Remove the dust container
empty it (fig. O). Remove the brush protector
by unhooking this from the bottom of the
114903_silv_Dampfbesen SDB 1500 A1_content_DE_AT_CH.indd 43
downwards vertically until
15
in an upright position
2
must click into
2
from
4
as per the instruc-
8
regularly and
6
Start-up / Cleaning and Maintenance
device and pulling it upwards (fig. P). Clean the
turbo brush by removing the dust accumu-
18
lated (Fig. Q). Reattach the brush protector
by hooking it onto the corresponding notches
on the underside of the device and clicking it
into place on the top of the device.
Keep the device in a cool, dry location and out
of the reach of children.
We recommend that you keep the original
packaging in a safe place. The manufacturer
accepts no liability for damage which occurs
through sending in the item to customer ser-
vices in the incorrect packaging.
Replacing the filter
Note: The filter must be replaced every
10
4–6 months or 100 cleaning cycles (one cycle
denotes use of a full water tank).
Remove the mains plug
when doing so.
Wait until the hot parts have cooled.
Remove the water tank
Remove the filter
lel to the motor body
Replace the filter with a new one and check
that it is seated correctly (Fig. R).
Put the water tank

Troubleshooting

ATTENTION! In cases of malfunction and
electrical damage, turn the device off immedi-
ately. Unplug the mains plug
socket and wait until the device has cooled.
7
from the socket
4
.
11
by lifting it upward paral-
10
.
2
back in place.
11
from the
4
GB
09.06.15 08:55
7
43