EdilKamin IDROPELLBOX Installations-, Betriebs- Und Wartungsanleitung Seite 28

COMPONENTS - SAFETY AND DETECTION DEVICES
Smoke thermocouple
on the smo e outlet. t reads the smo e temperature. t regula-
tes the ignition stage and shuts the oiler- replace do n i the
temperature is too high or too lo .
Flow sensor
ocated in the suction channel, it stops the thermal replace
hen the com ustion air o is not correct, hich could result
in negative pressure pro lems in the smo e circuit.
Feed Screw safety thermostat
laced near the pellet hopper. t disconnects the electrical suppl
to the gear motor i the temperature detected is too high.
Water temperature detector
t reads the ater temperature in the oiler- replace and sends
the circuit oard in ormation or pump management and oiler-
stove po er modulation. If the temperature is too high, it
starts a shutdown.
Water overheating safety thermostat with manual reset
measures the temperature o the ater inside the oiler- repla-
ce.
the temperature is too high, it cuts o the motor's electrical
po er suppl .
the thermostat is tripped, it must e reset using the utton
located inside e ternal door on the top le t part
Resistance
t sets o o the com ustion o the pellets and it remains lit until
the ame has een ignited.
Smoke extractor
" ushes the smo e into the ue and dra s out com ustion air
via a vacuum.
Gear motors
Activates the eed scre , hich allo s the pellets to e tran-
s erred rom the hopper to the com ustion cham er.
Pump (circulator)
" ushes ater to ard the heating s stem.
Closed expansion tank
"a sor s the variations in the volume o
de the oiler- replace due to the heating e ect.
Aheating technician must evaluate the need to add a second
tank to the existing one, depending on total amount of wa-
ter in the system.
N.B.:
IF THE BOILER-FIREPLACE BLOCKS, THE REASON WILL APPEAR ON THE DISPLAY AND THIS WILL BE
SAVED.
Overpressure valve
upon reaching the pressure stipulated on the plate, the s stem
is triggered to discharge the ater and consequentl the ater
must e topped up.
WARNING!!!! remember to carry out the connection with
the sewage system.
Manometer (M)
ocated inside the lo er panel
ater pressure inside the thermal replace. The ma imum re-
commended pressure is 1,5 ar hen the oiler- replace is on.
g. A
*
g. .
g.
2 relief valves:
ocated on the upper part, these allo
present hile the ater is eing loaded into the oiler- replace.
ATTE T
venting the oiler through the appropriate valves V - photo
a ove , ater leaving ma
electrical components, creating a hazard to persons and product
mal unction. Al a s direct the "ad usta le valve e haust
or ard and ma e sure that ater does not run over electrical
components.
Discharge valve
ocated inside the lo er panel this is to e opened i the ater
inside the thermal oiler- replace must e emptied.
ater contained insi-
- 28
-
g. A , it allo s reading the
M
*
V
or releasing an air
all on the circuit oard or other